DISASSEMBLE DRIVE BLADE ASSEMBLY - Step by Step
Back to Repair Index
|
|
 |
 |
| • Place 11/16 box wrench in vise | |
 |
 |
|
• Insert piston rod hex in box wrench • Remove driving blade jam nut with a 15/16 box wrench |
|
 |
 |
| • If jam nut is too tight use mallet to break free | |
 |
 |
| • Knock out ¼" dowel | |
|
|
 |
| • Remove driving blade | |
 |
 |
| • Use 1-1/8" box wrench to remove piston from | |
 |
 |
 |
 |
| • Pull piston rod through other end of return cylinder | |
| Previous | Next |
| <= Disassemble the Lower Nailer | Teflon Piston Seal Change => |