ASSEMBLE HANDLE ASSEMBLY - Step by Step
Back to Repair Index
    


Use the PLAY, Pause and Stop Controls Above
or click here for the Video and Sound.

 • Install cable into handle through flange end

 • Install safety trigger on to cable.
 • Place safety trigger on to 1/4" 0 dowel.
 • Place sheath of cable on to clamp surface.
 • Place handle half on to handle

 • Place 1/4-20 x 7/8" socket head cap screws in to front hole and snug screw

 • Place 1/4-20 x 3/4" socket head cap screws in to back hole closest
    to butt end and tighten both screws
 • Check for free movement and placement of cable sheath

 • Cable sheath should be flush to below flange

  • Use same procedures for all handle assemblies (short long and XL. etc.)

Back to Repair Index

Previous Next
<= Handle Disassemble and Reassemble Final Lower Nailer Reassembly =>