Replacing Small Roller Covers or Bearings - Model 50P Power Roller
Use the following steps when replacing the small roller covers or bearings for the Model 50P FLEX Power Roller.
| Replacing the Small Roller Covers for the 50P FLEX Power Roller |  |
| Lay the nailer down on its side. |  |
| Remove the set screw from the small roller mounting block using a 5/32" hex wrench. |  |
| Remove the small roller axel with the bearing and roller cover. |  |
| Take the bearing off the axel. |  |
| Remove the worn cover from the bearing. |  |
| Cover may be difficult to remove. Cut old cover off but be careful not to damage the bearing. |  |
| Replace the bearing cover using fingers or pliers. |  |
| Work the cover around the bearing to seat the cover evenly. |  |
| Identify the high ridge of the cover. |  |
| Slide the roller over the axel. |  |
| Insert the axel with roller -with roller -in the mounting block and tighten firmly. |  |
| Replace and tighten the set screw on the mounting block with the 5/32" hex wrench. |  |
| Repeat the procedure for the opposite side of the nailer. |  |