Model 50P FLEX Conversion Kit (back)
1.47
 

Click here for the Video
Use the PLAY, Pause and Stop Controls Above
or click here for the Video and Sound.

Installing the Model 50P FLEX
Conversion Kit.

Begin by removing any nails from the nail channel.
Mount the nailer upside-down in a padded vise.
Using a 3/16" Allen wrench, loosen the (4) hex screws with lock washers from the base of the existing nailer foot.
Lift the whole foot and channel off the nailer.

Remove the (4) 1-1/4" hex screws from the foot and save for re-installation.

 

You are now ready to install the new FLEX foot.
Using pliers, pull the drive blade assembly to the top of the nailer.
Install the nail channel into position over the drive blade.
Line up the drive blade with the opening in the nail channel.
Slide the FLEX foot sideways on to the nailer and nail channel.
Line up the 4 screw holes for each component; the foot, nail channel and the nailer body.
Replace and tighten the (4) 1-1/4" hex screws with lock washers using the 3/16" hex Allen wrench.
The nailer is now ready for functional testing.