Disassembly of the Model 50P Pneumatic Nailer.
| Remove the nailer cap. |  |
| Unscrew and remove the 4 screws holding the nailer cap. |  |
| Remove the nailer cap. |  |
| Activate the red safety trigger to release the safety yoke. |  |
| Remove the 2 safety yoke springs. |  |
| Remove the screw holding the trigger cable to the safety yoke. |  |
| Remove the safety yoke. |  |
| Remove the body plate. |  |
| Next, remove the 3 screws from the plunger using a 5/32" hex allen wrench. |  |
| Remove the plunger. |  |
| Remove the O-ring gasket. |  |
| Mount the nailer in the vise with the nailer shoe facing up. |  |
| Remove the 4 screws in body holding adapter foot & nail channel |  |
| Lift the channel assembly and adapter foot vertically off the driving blade. |  |
| Remove the rubber bumper. |  |
| Remove the driving blade assembly. If the driving blade is broken, tap out from the other side. |  |
| Nailer disassembly is complete. The nailer is now ready for replacement of seals or other worn components. |
|
