Drive Blade and Disassembly of the Model 50M.
| Disassembly and Rebuild for the Model 50M. |
|
| Place the nailer in a padded vise. |  |
| Using pliers, straighten the cotter pin on the tapered side of the #5 roller pin. |  |
| Remove the cotter pin by tapping it out.
Save the cotter pin for reinstallation. |
 |
| Tap and drive out the #5 roller pin. |  |
| Remove the plunger head, plunger spring and plunger spring pin by lifting straight out of the body. |  |
| You may need to pull the plunger spring pin out separately. |  |
| Slide off the rubber blade retainer, drive blade and plunger spring. |  |
| You are now ready to install a new drive blade. |
|
| To install a new drive blade, look for the milled T-slot on the plunger head. |  |
| Locate the label on the rubber retainer. Writing will be facing down towards the nailer body. |  |
| Slide the rubber blade retainer over the new drive blade. Push it flush to the underside of the plunger head. |  |
| Add the plunger spring and spring pin to the plunger. |  |
| Line up the slot on the spring pin with the drive blade which will face the front of the nailer. |  |
| Slide all components into the top of the nailer body. |  |
| Slide the #5 roller pin into the nailer while holding the plunger down. |  |
| Tap the pin with a mallet to drive it through. |  |
| Slide the cotter pin through the tapered end of
the #5 roller pin. Wrap the cotter pin legs to secure it in place. |
 |
| Wrap the cotter pin legs to secure it in place. |
 |
| Nailer is ready for cleats and functional testing. |
|
